Kodak 760H Carousel Slide Projector W/ Tray| Stack Loader| Case| Manual Remote

Description

Quoted Shipping To Continental US Only
Kodak 760H Carousel Slide Projector W/ Tray| Stack Loader| Case| Manual Remote.
A separate, circular tray holds several (usually 80 or 140) 35mm slides, and is filled with each slide placed in upside down and backwards, so that the image is projected with the correct orientation.
The tray has a metal plate on the bottom with an opening approximately 5 millimetres (0.20 in) wide, barely large enough to pass a single slide to the projection gate below it.
The projector body contains a motor which rotates the plastic main body of the tray (containing the slides) while the metal plate is fixed with the opening over the projection gate. As the tray is advanced, a reciprocating mechanism pushes the currently loaded slide back out into the tray, then the tray is rotated, dropping the next slide into position between the light source and lens.
The Kodak system offered three advantages over the straight-tray, horizontal-feed systems that were then common on the market.
The Carousel tray held slides in place with a locking ring on its hub, preventing slides from accidentally spilling out of the tray if it was dropped.
By using gravity to lower the slide into the projector, the chance of jamming was greatly reduced, since a warped slide would not descend past the point at which it encountered resistance in the mechanism.
The circular tray also enabled the projector to display automated shows without the need to manually reset the slide tray between performances.
Kodak also offered a stack loader
(Included)
that allowed running a stack of up to 40 slides without using a tray, but forward only; and clip sets holding up to 36 slides per clip. A box of 12 clips could store up to 432 slides, and keep them organized.
QUALITY GUARANTEE:
I inspect and test all items that come into my shop.  However, I deal with a large variety of items and my knowledge of some items is limited.  Because of this I offer a 48 hour inspection period on all items that I sell.  If you happen to find a problem with your item that I missed, please let me know within 48 hours of delivery. I will repair the item or refund your money if there is a problem that I cannot fix.  Good customer service is my only goal.  Please let me know immediately if there is a problem with your item.
If there is any shipping damage to your item please keep all packaging until the claim is settled as this is required by all shippers.  Failure to keep the packaging will invalidate any return or refund on the item.